Moulin de Vies

Moulin de Vies

nelly grosjean
founder

Chemin des Moulins 1
2516 Lamboing
Plateau de Diesse
Switzerland

contact@moulindevies.com

+41 (0)32 535 79 79
+ 41 (0)7 84 06 00 35

questions and comments?

5 + 2 =

how to get there

Lamboing is located halfway between Neuchâtel and Biel, at an altitude of 800m, on the Diesse plateau, in the Chasseral regional nature park.

from Neuchâtel, la Neuveville, Prêles in the direction of Lamboing:
At the sawmill on your left, turn right. After a few meters, at the hamlet, turn left. Turn left again to enter the hamlet. Continue straight on. The mill is at the top of the hamlet on your right.

from Twann:
After Reto's Glas-Atelier (on your left). You will see a hamlet on the right. Turn right at the beginning of the hamlet and then immediately left. Drive through the hamlet. Continue straight on. The mill is at the top of the hamlet on your right. This hamlet is located before you reach the sawmill and well before the village.

de Diesse:
At the Auberge du Lion Rouge, the former SCHOOL, turn right. Continue straight ahead. At the Reparex garage, take the road on your left on the side of the garage. Go down, the Moulin de Vies is a little further down on the left.

d'Orvin :
When you reach the old school, turn left. Continue straight ahead. At the Reparex garage, take the road on your left on the side of the garage. Go down, the Moulin de Vies is a little further down on the left.

by train to La Neuveville:
take the bus and ask for the stop Scierie or Garage Reparex

Nearest train stations:
la Neuveville and take the bus which stops 200 m from the mill. Twann then Taxi (4km). Ligerz-Gléresse and take the funicular to Prêles, then 2 km walk from the mill or bus from the funicular.

airports :
Bern, Zürich Geneva, Basel (then take the train to Neuchâtel or Bienne)

motorway:
exit at La Neuveville then direction Prêles-Lamboing

helicopter :
for authorization, contact heli@bazl.admin.ch

GPS point:
47.113049, 7.138352